mcHF Update – Serial EEPROM, New Tuning Knob

While checking some of the posts on the mcHF Yahoo Group, I came across one from Andreas that emphasized the importance of installing the optional EEPROM. If the EEPROM is not installed the radio saves settings to the CPU’s FLASH memory whenever the radio is turned off. All of this memory writing adds up and can lead to failure of the FLASH memory. Since I don’t want to worry about replacing the CPU in the future I ordered the recommended EEPROM (24LC1026) chip and installed it on the UI board. I also installed the required 0.1uF capacitor using the smallest through-hole component I could find. Upon booting up the transceiver the EEPROM was detected by the firmware and the radio seems to be working perfectly. This was an easy and worthwhile upgrade, especially since the EEPROM only costs about $3.50 and should protect the FLASH memory from being worn out in the future.

After some extensive searching I finally found the perfect tuning knob for the mcHF. OKW makes a very nice line of knobs, part of which is a series designed for communications gear. To match my mcHF’s black enclosure I bought the A3140069 which is 40mm in diameter and mounts to the encoder’s 6mm shaft using a compression collet. This knob can take two different styles of cover (with or without finger dimple) in an assortment of colors. I went with the A3240109 cover which features a finger dimple for faster tuning. This is a huge upgrade over the tuning knob provided with my case and really improves both the looks and functionality of the mcHF. Not bad for under $5.

Leave a Reply

Your email address will not be published. Required fields are marked *